ELTRON LP 2042 PRINTER DRIVERMarch 25, 2020
Refer to Section 2 – Operation, for informationon loading labels and using your printer. Place the spindle inside theroll of labels or tags. Windows Printer DriverPaper Quality, The print speed can be adjusted to compensatePrint Speed for manufacturing differences in label stock. TroubleshootingWhile lifting the lower head bracket, removethe tension release rod. Carefully lift up themechanism and disconnect the four cables thatlead to the main board noting their positions.
|Date Added:||6 December 2009|
|File Size:||17.5 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The Eltron Company LP2042 Printer User Manual
Supplies can be ordered from Eltronby calling 1 Page 44 Accessories Rev. A battery in the cartridge prevents memory loss if the printer power is switched off ordisconnected. Check interface cable connectionsfrom computer to printer. Check this area first beforeHead checking the remainder of the print mechanism. When power is first applied to the printer, tapping the FEED controlwill cause the paper to advance approximately0. Refer to Section 2 – Operation, for informationon loading labels and using your printer.
This provides easy access to the inside of theprint mechanism. To access this menu, select Options from theprinter setup control panel.
Getting StartedInstallation The following sections will step you through theinstallation of the printer and Create-A-LabelTools software. Page 14 Getting Started Rev.
Figure Center The Labels Rev.
What’s missing? Tell us about it.
After printing a label, tapping the FEEDcontrol will cause the paper to advance to thetop of the next label. Next, install the head tension spring aligning itwith the two posts on the print carriage.
Always use high quality, Eltron approved labels. Page 42 Troubleshooting Rev. Check that the printerpower switch is in the OFF 0 position.
Thebattery may explode causing damage or injury. The adhesive comes in contact with the printhead or the mechanism and the label peels offthe liner. Page 48 41 Mo re la nd Rd. Carefully lift up themechanism and disconnect the four cables thatlead to the main board noting their positions.
Selecting a slower print speed can improve theappearance of lines sltron text on some labelstocks. Figure Loading LabelsTop FeedIf loading tags, place the roll in the top cover sothat the end feeds from the bottom as shownin Figure The discharge of electrostatic energy that accumulates on the surface of the human body orother surfaces can damage or destroy the printhead or electronic components used in thisdevice. Figure Feed Slot Rev.
Paper Label Size Before creating a label, the paper size for thecurrently loaded labels must be selected in thecontrol panel. Printer appears to be working,but nothing is printed.
Page 23 OperationThreading The If your printer is equipped with the optionalLabel Dispenser label dispenser and you would like the printerto automatically peel adhesive labels from thebacking liner, follow the steps below: From the DOS prompt,enter B: CAUTIONThe discharge of electrostatic energy that accumulates on the surface of the human body orother surfaces can damage or destroy the printhead or electronic components used pribter thisdevice.
The easiest way to prevent this typeof jam is to always use Eltron approved labels.
Eltron LP Manuals
prinyer OperationAutoSense Your printer is equipped with a sensor capableGap Sensor of detecting the gap between labels while theyAdjustment are being printed. OperationCleaning The As you use your printer, the print head mayPrint Head become dirty resulting in poor print quality.
Page 7 1Getting StartedThis section provides information on the installation of the printer and software. Peel the second and third labels off the backing liner. Place the spindle inside eltroon of labels or tags. Print HeadDo not unplug the print head.